reikan focal pro lens calibration download

The Chart card shows the Quality Ratio chart, which shows how well the lens is performing. In this case, it shows that the lens is in need of calibration, and shows the number of measurements taken. The Test Results Overview card shows a few essential test results. The gauge runs from red on the left representing poor calibration, through to green on the right which represents good calibration (the marker is the black line – in the example above pushed to the far left as this lens is not well calibrated). The Calibration State card indicates the current status of the lens calibration. The Summary page shows the essential results for the Calibration Check: The information obtained is updated as the test runs. The test requires no user interaction and takes a few minutes to run. You can start the test with the Start button in the Status tab, or with the Start button on the test footer bar. Once the setup steps above are complete, you are ready to run the Calibration Check. When the test starts, there is an information message that is shown to remind you to adjust the focus points for both modes to the centre, but FoCal will (currently) not verify this, so ensure you have correctly performed this step otherwise the results may be incorrect. If Live View will not start, you will need to stop the test, disconnect the camera and confirm the Live View focus position with the camera disconnected, then reconnect and restart Calibration Check. Note : not all cameras will allow you to enable Live View when connected to a computer (e.g. Again, you may need to change the focus mode to single point mode in order to set the focus point position. Start Live View, and ensure the focus point is also set to the centre.You may need to change the focus mode to single-point mode in order to set the position. Look through the viewfinder, and ensure the focus point is set to the centre focus point.Once you have successfully confirmed your camera and target setup, you need to ensure that both Live View and non-Live View focus points are set to the centre point: You can access Target Setup from the Target Setup button on the test footer bar, from Camera menu or from the Camera status page. Target Setup utility is an automated utility which will help you do this - all the information you need is here. In order to use Calibration Check, you need to ensure that the camera and target are set up correctly.

You can open Calibration Check either from the Camera menu, or from the Calibration Check card on the Camera page. This tool required NO user interaction, and can even run with (supported) cameras that do not have any focus adjustment capability. The FoCal Calibration Check utility can assess the current state the phase-detect autofocus system of your camera/lens and determine if calibration is required.

Reikan focal pro lens calibration download